Call (253) 366-2904
Royal Flush Plumbing logo

Garbage Disposal Jammed or Leaking

A disposal that hums without turning, goes silent at the switch, or drips into the cabinet. Here is what each one usually means, the checks that are safe to make yourself, and how we fix it in Tacoma-area kitchens.

Why Is My Garbage Disposal Humming but Not Turning?

Because the motor is getting power but the plate inside cannot spin. Something hard, like a fruit pit, a bone or a bottle cap, has wedged between the turntable and the grinding ring, or the bearings have seized with age. Running it longer only overheats the motor, so switch it off first.

Not every disposal call ends at the disposal. Last fall in Frederickson, the kitchen sink above it had to be fixed first. Jerry set the sink, put supports under it and hooked up the right-hand basin while the other side waited for the homeowner’s new disposal, then Devin re-mounted the undermount sink so it would hold and, once the adhesive had set, came back to install the disposal under it. A disposal hangs from the sink, so a sink that is working loose takes the disposal with it.

Request Service
The underside of a stainless undermount sink with a white plastic drain and trap, faucet hoses and a length of lumber across a stained cabinet floor
The drain under the right-hand basin of a Frederickson kitchen sink our crew re-set in fall 2025, hooked up first while the other basin waited for the homeowner’s new disposal.

What Makes a Disposal Hum, Stop or Leak

The causes we find, roughly from most to least common.

Something Wedged Inside

A fruit pit, a bone, a bottle cap or a piece of glass lodged between the turntable and the grinding ring stops the plate while the motor keeps humming.

A Tripped Overload

When the motor overheats, a reset button on the bottom of the unit pops out and cuts the power. The disposal stays silent until the motor cools and the button is pressed.

No Power at the Switch or Outlet

A tripped breaker, a worn wall switch or a disposal that has come unplugged under the sink all look like a dead motor.

A Leak at the Sink Flange

Water around the top of the unit usually means the seal between the sink and the disposal’s mounting flange has failed, or the mounting ring has worked loose.

A Leak at the Drain or Dishwasher Connection

Drips from the side point at the drain elbow or the dishwasher hose, which can often be resealed or replaced without a new disposal.

A Cracked Body

Water from the bottom of the housing, or from around the reset button, means a seal inside has failed, and the unit needs replacing.

A Clog Below the Disposal

If the disposal runs normally but the sink will not drain, the blockage is in the trap or the drain line, not the unit. Our slow and clogged drains page covers what comes next.

A humming or silent disposal is often fixed in place. A leak from the body, or a motor that keeps tripping, usually means a new unit.

What You Can Safely Check

These take a few minutes, and none of them means reaching inside the disposal.

1

Turn It Off and Cut the Power

Switch the disposal off, then unplug it under the sink or turn off its breaker before you do anything else. Never put your hand into the disposal.

2

Press the Reset Button

Let the motor cool for a few minutes, then press the reset button on the bottom of the unit and try the switch again.

3

Free the Turntable From Below

Many disposals have a hex socket in the center of the bottom. With the power off, a matching hex wrench worked back and forth can free a jam from underneath. Lift out anything loose with tongs, not fingers.

4

Find the Leak With a Paper Towel

Dry the unit, run some water and touch a paper towel to the sink flange, the drain connection, the dishwasher hose and the bottom of the unit to see where the water first appears.

When to Stop

If the breaker trips again, you smell burning, water is coming from the body of the unit or both basins are backing up, stop testing and call us. Do not keep switching a humming disposal on, and do not pour chemical drain cleaner into one: it sits in the unit and can splash back on whoever clears it.

How We Fix It

The fix follows the cause, and we check the sink and the drain before we condemn the unit.

Clear the Jam and Test the Motor

We free the turntable, remove what jammed it and check that the motor runs cleanly before we leave.

Learn more →

Reseal, Re-mount or Reconnect

A new flange seal, a tightened mounting ring, a resealed drain or dishwasher connection, and a properly supported sink when that is the problem, as it was in Frederickson.

Learn more →

Replace the Unit

A new disposal when the body leaks or the motor is worn out, including one you bought yourself.

Learn more →

Clear the Drain Below

When the disposal runs but the sink will not drain, we clear the trap and the line behind it.

Learn more →

Urgent Calls Around the Clock

We answer urgent calls around the clock, and a sink that is backing up or leaking into the cabinet goes ahead of routine work.

Learn more →

Repairs and replacements are on our garbage disposal page, or browse all common problems.

Why Tacoma Homeowners Call Royal Flush

Veteran-Owned & Local

Family-operated out of Tacoma, serving Pierce and King County.

Upfront Pricing

You approve a clear price before any work starts. Estimates are free.

Licensed & Insured

Washington license #ROYALFP787R1, bonded and fully insured.

Fast Local Response

Urgent calls answered around the clock, from a crew based on Tacoma’s south side.

Flexible Payments Through Wisetack

Spread a larger repair over monthly payments, with no prepayment penalties and no hidden fees. VIP Home Protection members save 10% on every service.

Garbage Disposal Questions

Straight answers before you pick up the phone.

No. Even switched off, the unit can start if the switch is bumped, and the grinding ring has sharp edges. Unplug it or turn off its breaker, then use tongs or pliers to lift out anything you can see, and free the turntable from underneath with a hex wrench instead.

Usually not when the water comes from the housing. That means a seal inside the unit has failed, and it is not a part worth replacing on its own. Leaks at the sink flange or the drain connection often run down the outside and drip from the bottom too, so we dry the unit and find the source first.

Don’t Gamble On Your Plumbing!

Veteran-owned, licensed and local. Call us or request service about a disposal that hums, stops or leaks anywhere in Tacoma and the South Sound, and we will tell you what we find before any work starts.

(253) 366-2904

Call NowRequest Service